Supermicro A+ Server 2021TM-BTRF/BIBXRF — Supermicro A+ Server 2021TM-BTRF/BIBXRF User Manual PDF (EN)

A+ SERVER 2021TM-BTRF/BIBXRF User's Manual For grounding purposes, make sure your computer chassis provides excellent conductivity between the power supply, the case, the mounting fasteners and the serverboard. The serverboard is shipped in antistatic packaging to avoid electrical static discharge. When unpacking the board, make sure the person handling it is static protected. Unpacking 5-2 Serverboard Installation This section explains the fi rst step of physically mounting the H8DMT-F/H8DMT- IBXF into the SC827B-R1200B chassis. Following the steps in the order given will eliminate the most common problems encountered in such an installation.

To remove the serverboard, follow the procedure in reverse order. Installing to the Chassis Access the inside of the system by removing the screws from the back lip of 1. the top cover of the chassis, then pull the cover off. The H8DMT-F/H8DMT-IBXF requires a chassis big enough to support a 16.4" 2. x 6.5" serverboard, such as Supermicro's SC827B-R1200B. Make sure that the I/O ports on the serverboard align properly with their 3. respective holes in the I/O shield at the back of the chassis. Carefully mount the serverboard to the serverboard tray by aligning the board 4. holes with the raised metal standoffs that are visible in the chassis.

Insert screws into all the mounting holes on your serverboard that line up 5. with the standoffs and tighten until snug (if you screw them in too tight, you might strip the threads). Metal screws provide an electrical contact to the serverboard ground to provide a continuous ground for the system. Finish by replacing the top cover of the chassis. 6. Warning: To avoid damaging the motherboard and its components, do not apply any force greater than 8 lbs. per square inch when installing a screw into a mounting hole. 5-2