Supermicro A+ Server 2021TM-BTRF/BIBXRF — Supermicro A+ Server 2021TM-BTRF/BIBXRF User Manual PDF (EN)

A+ SERVER 2021TM-BTRF/BIBXRF User's Manual LAN1/2 Enable/Disable Change the setting of jumper JPL to enable or disable the LAN Ethernet ports on the serverboard. See the table on the right for jumper settings. The default setting is enabled. BMC/Video Enable/Disable JBMC1 connector allows you to enable or disable the IPMI and Video. The default position is on for both pin 1 and pin 2 to enable both IPMI and VGA. See the table on the right for jumper settings. I 2 Jumpers JI 2 set to the same setting See the table on the right for jumper settings. Watch Dog Enable/Disable Jumper J21 controls the Watch Dog function.

Watch Dog is a system monitor that can reboot the system when a software application hangs. Jumping pins 1-2 will cause WD to reset the system if an application hangs. Jumping pins 2-3 will generate a non- maskable interrupt signal for the application that hangs. See the table on the right for jumper settings. Watch Dog must also be enabled in BIOS. Note: When enabled, the user needs to write their own application software in order to disable the Watch Dog Timer.

5-20 JLAN1/2 Enable/Disable Jumper Settings (JPL) Jumper Setting Defi nition Pins 1-2 Enabled (Default) Pins 2-3 Disabled VGA Enable/Disable Jumper Settings (JPG1) Jumper Setting Defi nition Pins 1-2 BMC and Video Enabled Pins 2-3 BMC and Video Disabled I-Exp. Slots JI2C2 allow you to Management Bus (I2C) ots. The default setting Both jumpers must be I2C to PCI-X/PCI-E Slots Jumper Settings (J12/J13) Jumper Settings Defi nition JI2C1: Closed JI2C2:Closed Enabled JI2C1: Open JI2C2: Open Disabled Watch Dog Jumper Settings (J21) Jumper Setting Defi nition Pins 1-2 Reset Pins 2-3 NMI Open Disabled