3. If you are using a disk drive, connect the printer to your drive unit using the serial port as in Step 2 above. Connect the drive to the computer. If any of the ports are not compatible with your cables, consult your dealer or your computer and disk drive manuals. Refer to Figure 1-21 below. Figure 1-21: Multiple hookup (serial) If you are connecting the MPS 1000 to your computer using the parallel port: 1. Refer to the Figure 1-22. Plug one end of your cable connector (36 pins) into the cable connector of the MPS printer. The plug is shaped so that there is only one way it will fit the connector. 2. Secure the plug to the printer with the wire clips on each side of the connector.
These clips ensure that your cable will not be loosened or unplugged accidendy. If your cable has a grounding wire, fasten it to the grounding screw below the connector. 3. Next, connect the other end of the printer cable to your computer. On most computers, you can easily find the cable connector for the printer cable. But, if you are not sure, consult your computer manual or your dealer. 20