cisco — Troubleshooting Automated Double Authentication

Troubleshooting Automated Double Authentication To troubleshoot automated double authentication, use the following commands in privileged EXEC mode: Procedure Configuring Authentication Troubleshooting Automated Double Authentication Command or Action Purpose Device(config)# ip trigger-authentication timeout 120 Step 4 interface type number Example: Device(config)# interface gigabitethernet 1/0/17 Configures an interface and enter the interface configuration mode. Step 5 ip trigger-authentication Example: Device(config-if)# ip rigger-authentication Applies automated double authentication to the interface. Step 6 end Example:

Device(config-if)# end Exits interface configuration mode and returns to privileged EXEC mode. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password, if prompted. Step 2 show ip trigger-authentication Example: Device# show ip trigger-authentication Displays the list of remote hosts for which automated double authentication has been attempted (successfully or unsuccessfully). Step 3 clear ip trigger-authentication Example: Device# clear ip trigger-authentication Clears the list of remote hosts for which automated double authentication has been attempted.

(This clears the table displayed by the show ip trigger-authentication command.) Step 4 debug ip trigger-authentication Example: Device# debug ip trigger-authentication Displays debug output related to automated double authentication. Configuring Authentication 29