hostx Password = “welcome” User-Service-Type = Framed-User, Framed-Protocol = PPP, cisco-avpair = “lcp:interface-config=ip unnumbered fastethernet cisco-avpair = “ip:inacl#3=permit tcp any 172.21.114.0 0.0.0.255 eq telnet”, cisco-avpair = “ip:inacl#4=deny icmp any any”, cisco-avpair = “ip:route#5=10.0.0.0 255.0.0.0”, cisco-avpair = “ip:route#6=10.10.0.0 255.0.0.0”, cisco-avpair = “ipx:inacl#3=deny any” Example: Configuration of the AAA Server for Second-Stage Per-User Authentication and Authorization This section contains partial sample AAA configurations on a RADIUS server.
These configurations define authentication and authorization for a user with the username “user1,” who will be user-authenticated in the second stage of double authentication. TACACS+ servers can be configured similarly. Three examples show sample RADIUS AAA configurations that could be used with each of the three forms of the access-profile command. The first example shows a partial sample AAA configuration that works with the default form (no keywords) of the access-profile command. Note that only ACL AV pairs are defined. This example also sets up the access-profile command as an autocommand.
user1 Password = “welcome” User-Service-Type = Shell-User, cisco-avpair = “shell:autocmd=access-profile” User-Service-Type = Framed-User, Framed-Protocol = PPP, cisco-avpair = “ip:inacl#3=permit tcp any host 10.0.0.2 eq telnet”, cisco-avpair = “ip:inacl#4=deny icmp any any” The second example shows a partial sample AAA configuration that works with the access-profile merge form of the access-profile command. This example also sets up the access-profile merge command as an autocommand.
user1 Password = “welcome” User-Service-Type = Shell-User, cisco-avpair = “shell:autocmd=access-profile merge” User-Service-Type = Framed-User, Framed-Protocol = PPP, cisco-avpair = “ip:inacl#3=permit tcp any any” cisco-avpair = “ip:route=10.0.0.0 255.255.0.0", cisco-avpair = “ip:route=10.1.0.0 255.255.0.0", cisco-avpair = “ip:route=10.2.0.0 255.255.0.0" The third example shows a partial sample AAA configuration that works with the access-profile replace form of the access-profile command. This example also sets up the access-profile replace command as an autocommand.
user1 Password = “welcome” User-Service-Type = Shell-User, cisco-avpair = “shell:autocmd=access-profile replace” User-Service-Type = Framed-User, Framed-Protocol = PPP, cisco-avpair = “ip:inacl#3=permit tcp any any”, cisco-avpair = “ip:inacl#4=permit icmp any any”, cisco-avpair = “ip:route=10.10.0.0 255.255.0.0", cisco-avpair = “ip:route=10.11.0.0 255.255.0.0", cisco-avpair = “ip:route=10.12.0.0 255.255.0.0" Configuring Authentication Example: Configuration of the AAA Server for Second-Stage Per-User Authentication and Authorization Configuring Authentication 42