(Optional)ConfiguringthePortAggregationProtocolLearnMethodandPriority To configure the PAgP learn method and priority, perform this procedure: Procedure Configuring EtherChannels (Optional) Configuring the Port Aggregation Protocol Learn Method and Priority Command or Action Purpose Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 port-channel load-balance extended {dst-ip | dst-mac dst-port | ipv6-label | l3-proto | src-ip | src-mac | src-port } Example: Device(config)# port-channel load-balance extended dst-ip dst-mac src-ip Configures an EtherChannel extended load-balancing method. The default is src-mac.
Select one of these load-distribution methods: • dst-ip—Specifies destination-host IP address. • dst-mac—Specifies the destination-host MAC address of the incoming packet. • dst-port—Specifies the destination TCP/UDP port. • ipv6-label—Specifies the IPv6 flow label. • l3-proto—Specifies the Layer 3 protocol. • src-ip—Specifies the source host IP address. • src-mac—Specifies the source MAC address of the incoming packet. • src-port—Specifies the source TCP/UDP port. Step 4 end Example: Device(config)# end Returns to privileged EXEC mode. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Enter your password if prompted. Configuring EtherChannels 19