Channel group 1,[146 s left to exit dampening state] LACP port Admin Oper Port Port Port Flags State Priority Key Key Number State Fa1/1 FA hot-sby 30000* 0x1 0x1 0x103 0x7 Fa1/2 SA bndl 32768 0x1 0x1 0x102 0x3D Example: Configuring Standalone Mode on EtherChannel This example shows how to configure the Standalone mode or Independent mode on an Port channel: Device(config)# interface port-channel 1 Device(config-if)# no port-channel standalone-disable Device(config-if)# end This example shows how to verify the configuration of the Standalone mode on a Port Channel interface: Device# show running-config interface port-channel 1 Building configuration... Current configuration: !
interface Port-channel1 no ip address no switchport no port-channel standalone-disable end Example: Configuring Auto LAG This example shows how to configure Auto-LAG on a switch Device> enable Device# configure terminal Device(config)# port-channel auto Device(config-if)# end Device# show etherchannel auto This example shows the summary of EtherChannel that was created automatically. Device# show etherchannel auto Flags:
D - down P - bundled in port-channel I - stand-alone s - suspended H - Hot-standby (LACP only) R - Layer3 S - Layer2 U - in use f - failed to allocate aggregator M - not in use, minimum links not met u - unsuitable for bundling w - waiting to be aggregated d - default port A - formed by Auto LAG Number of channel-groups in use: 1 Number of aggregators: 1 Group Port-channel Protocol Ports ------+-------------+-----------+----------------------------------------------- 1 Po1(SUA) LACP Gi1/0/45(P) Gi2/0/21(P) Gi3/0/21(P) This example shows the summary of auto EtherChannel after executing the port-channel 1 persistent command. Configuring EtherChannels Example:
Configuring Standalone Mode on EtherChannel Configuring EtherChannels 33