EnablingRouteLeakingbetweenEVPN-enabledVRFandGlobalRoutingTable Route Leaking between an EVPN-enabled VRF and the Global Routing Table (GRT) is required to access shared services such as DNS or DHCP, which are reachable through the global routing table. To configure route leaking on a leaf node, perform the following steps. Procedure Configuring EVPN VXLAN External Connectivity Enabling Route Leaking between EVPN-enabled VRF and Global Routing Table Command or Action Purpose Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Step 3 interface interface-id Example:
Device(config)# interface GigabitEthernet1/0/30 Enters the interface configuration mode for the specified interface. Step 4 vrf forwarding vrf-name Example: Device(config-if)# vrf forwarding green Associates the VRF with the interface. Note The interface must be associated with the same VRF for which the Layer 3 VNI has been configured for the EVPN VXLAN network. Step 5 ip address ip-address Example: Device(config-if)# ip address 192.168.3.203 255.255.255.0 Configures the IP address for the interface. Step 6 end Example: Device(config-if)# end Returns to privileged EXEC mode. Command or Action Purpose Step 1 enable Example: Device> enable Enters privileged EXEC mode.
Enter password, if prompted. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Configuring EVPN VXLAN External Connectivity 8