cisco — Configuring VRF-Aware Services for uRPF

Configuring VRF-Aware Services for uRPF uRPF can be configured on an interface assigned to a VRF, and source lookup is done in the VRF table. Procedure Configuring Multi-VRF CE Configuring VRF-Aware Services for uRPF Command or Action Purpose Device(config-if)#vrf forwarding A Step 8 ip address ip-address subnet-mask Example: Device(config-if)#ip address 1.1.1.2 255.255.255.0 Enter the IP address for the interface. Step 9 exit Example: Device(config-if)exit Exits the interface configuration mode. Command or Action Purpose Step 1 enable Example: Device>enable Enables privileged EXEC mode. Enter your password if prompted. Step 2 configure terminal Example:

Device#configure terminal Enters global configuration mode. Step 3 interface interface-id Example: Device(config)#interface gigabitethernet 1/0/1 Enters interface configuration mode, and specifies the Layer 3 interface to configure. Step 4 no switchport Example: Device(config-if)#no switchport Removes the interface from Layer 2 configuration mode if it is a physical interface. Step 5 ip vrf forwarding vrf-name Example: Device(config-if)#ip vrf forwarding vpn2 Configures VRF on the interface. Step 6 ip address ip-address Example: Enters the IP address for the interface. Configuring Multi-VRF CE 16