Return to Configuration Example for Optimized Layer 2 Overlay Multicast for IPv4 and IPv6 with Underlay Multicast Replication . Return to Configuration Examples for Optimized Layer 2 Overlay Multicast, on page 10 Verifying Optimized Layer 2 Overlay Multicast with Default MDT for IPv4 and IPv6 Traffic The following sections provide sample outputs for show commands to verify Optimized Layer 2 Overlay Multicast with Default MDT for IPv4 and IPv6 multicast traffic on the devices in the topology configured above. To see the outputs of show commands for IPv4 multicast traffic, refer Verifying Optimized Layer 2 Overlay Multicast with Default MDT in the Underlay , on page 60 .
The outputs of show commands for IPv6 multicast traffic are the following: Outputs to verify configuration on VTEP 1 Outputs to verify configuration on CGW Outputs to verify configuration on VTEP 3 Outputs to verify configuration on Spine Switch 1 Outputs to verify configuration on Spine Switch 2 Outputs to verify configuration on VTEP 1 MLD exclude Leaf-01# show ip pim neighbor PIM Neighbor Table Mode:
B - Bidir Capable, DR - Designated Router, N - Default DR Priority, P - Proxy Capable, S - State Refresh Capable, G - GenID Capable, L - DR Load-balancing Capable Neighbor Interface Uptime/Expires Ver DR Address Prio/Mode 172.16.13.1 GigabitEthernet1/0/1 1d00h/00:01:19 v2 1 / S P G Configuring Optimized Layer 2 Overlay Multicast Verifying Optimized Layer 2 Overlay Multicast with Default MDT for IPv4 and IPv6 Traffic Spine Switch 1 Spine Switch 2 neighbor 172.16.255.2 send-community both neighbor 172.16.255.2 route-reflector-client neighbor 172.16.255.3 activate neighbor 172.16.255.3 send-community both neighbor 172.16.255.3 route-reflector-client neighbor 172.16.255.4 activate neighbor 172.16.255.4 send-community both neighbor 172.16.255.4 route-reflector-client neighbor 172.16.255.6 activate neighbor 172.16.255.6 send-community both neighbor 172.16.255.6 route-reflector-client exit-address-family !
ip pim rp-address 172.16.255.255 ip msdp peer 172.16.254.2 connect-source Loopback1 remote-as 65001 ip msdp cache-sa-state ! end neighbor 172.16.255.1 send-community both neighbor 172.16.255.1 route-reflector-client neighbor 172.16.255.3 activate neighbor 172.16.255.3 send-community both neighbor 172.16.255.3 route-reflector-client neighbor 172.16.255.4 activate neighbor 172.16.255.4 send-community both neighbor 172.16.255.4 route-reflector-client neighbor 172.16.255.6 activate neighbor 172.16.255.6 send-community both neighbor 172.16.255.6 route-reflector-client exit-address-family !
ip pim rp-address 172.16.255.255 ip msdp peer 172.16.254.1 connect-source Loopback1 remote-as 65001 ip msdp cache-sa-state ! end Configuring Optimized Layer 2 Overlay Multicast 78