⚫ Note about Use Please be aware of and accept the following when you introduce or use Omron products: (1) Please use Omron products in compliance with usage conditions including rating and performance limits. (2) Please confirm the fitness of Omron products in your application and use your own judgment to determine the appropriateness of using them in such application. Omron shall not warrant the fitness of Omron products in customer applications. (3) Please confirm in advance that Omron products are properly wired and installed for their intended use in your overall system.
(4) When using Omron products, please make sure to (i) maintain a margin of safety between the published rated and performance values, and the application requirements, (ii) design to minimize risks to customer application in case of failure of Omron products, such as introducing redundancy, (iii) introduce system-wide safety measures to notify risks to users, and (iv) conduct regular maintenance on Omron products and customer application.
(5) Omron assumes no responsibility for any direct or indirect loss, damage and expense resulting from infection of our products, installed software, any computer devices, - DDoS attack (distributed DoS attack), computer programs, network, and databases with the followings: - Computer virus and other technically harmful program, and - Unauthorized access. Please conduct the followings by yourself: (i) antivirus software install, (ii) data input/output, (iii) lost data recovery, ( ⅳ ) protections against computer virus that contaminate Omron products or the installed software, and ( ⅴ ) measures to protect Omron products from unauthorized access.
(6) Omron products are designed and manufactured as general-purpose products for use in general industrial applications. They are not intended to be used in the following critical applications. If you use Omron products in the following applications, Omron shall not provide any warranty for such Omron products, unless otherwise specifically agreed or unless the specific applications are intended by Omron.
(a) Applications with stringent safety requirements, including but not limited to nuclear power control equipment, combustion equipment, aerospace equipment, railway equipment, elevator/lift equipment, amusement equipment, medical equipment, safety devices and other applications that could cause danger/harm to human body and life. (b) Applications that require high reliability, including but not limited to supply systems for gas, water and electricity, etc., 24-hour continuous operating systems, financial settlement systems and other applications that handle rights and property.
to outdoor equipment, equipment exposed to chemical contamination, equipment exposed (c) Applications under severe condition or in severe environment, including but not limited 4