2 Common Specifications of IAG 2-4-2 Restore • Correctly install each device that is necessary for equipment control. Correctly download created projects and settings into each of them and make sure the devices run without errors. • Create IAGs necessary for executing a restore in the HMI project by using the Sysmac Studio and download it to an NA-series Programmable Terminal. The IAGs used for executing a restore are as follows: a) BRInitialization b) ConfigureRestore c) RestoreFromUSBMemory • Insert an SD Memory Card to all the NJ/NX-series CPU Units, NX-series Communication Control Units and NA-series Programmable Terminal that are specified as target devices for the restore.
• Insert a USB flash drive containing the restore data into the NA-series Programmable Terminal. Specifying Data for Restoration Use the screen on the NA-series Programmable Terminal and display ConfigureRestore. Specify data for restoration. • In the Restore data field, select the backup data folder whose name consists of the name you specified for Backup name and the date and time information (year, month, day, hour and minute). Restore data settings Display the folder selection screen Save button • Once the settings are complete, touch the Save button to save the settings. Additional Information You can select the latest backup data for restore.
It is allowed only when the last backup was successfully completed by using IAGs. 2-24 Programmable Terminals NA-series Practices Guide NJ/NX/NA-series Backup and Restore IAG (V127) Preparation