Atari Games Cops — Cops TM-398 1st Printing COLOR COVERS_Page_2.jpg

CHAPTER 3 — TROUBLESHOOTING AND MAINTENANCE dct) Ct parts as needed. — Check the voltage levels to the video display PCB. h Picture wavers or is too small Check the B+ to the video display. (Refer to the video display manual.) Check the fuses on the power supply. Attraction panel does not light Check the bulb in the attraction panel. he - Picture is wavy Check to see that the game is plugged in and powered on. Check the line fuse if no power is present. Check the display brightness. Check the solder connections on the line filter and the transformer. Check the edge connector to the PCB. Check the harnesses and connectors to the video display PCB.

Check the voltage levels to the video display PCB. Run through the following checklist. If you answer no to any question, you have a problem with the video display, not with the game circuitry. In this case, refer to your video display service manual. a. Do you have power to the video display? b. Are the video display’s filaments lit? c. Do you have the correct voliage to the video display? Ne ONOARONM> Video Display Problems Screen is dark Check the speaker volume setting: make sure the volume isn’t zero! Check the Sound Test in the Test Mode. Check to make sure that the CD-ROM and laser disc are properly loaded in their players. Check the harness connections on the CD-ROM player.

Check the resistance of the speakers for 4 Ohms on all five speakers. Check the connection of the monitor ground wire to the monitor. Check the connections of the sync inputs. Picture is upside down or reversed If you replaced the monitor recently, check the horizontal or vertical yoke wire connections to the video display. They may be switched. Convergence, Use the adjustment procedures in your video display manual. purity or color problems Picture is not centered Use the centering procedures in your video display manual. Only still picture appears The laser disc player is probably not communicating with the Logic PCB. Check the connection to the laser disc player from the PCB.

Check for a blown fuse on the power supply PCB, and check for 5 Volts at the laser disc player. CD-ROM Problems CD won't eject (tray won't open) Turn the power off, then on again. Immediately thereafter push the eject button. Table 3-1 3-2 General Troubleshooting