Copying Parameters Between E5CC Temperature Controllers Quick Start Guide (FR)

Copying Parameters Between E5CC Temperature Controllers Quick Start Guide Version 1.0 September 2015 Page 1 of 37

Стр. 1

Copying Parameters between E5CC Temperature Controllers

Copying Parameters between E5CC Temperature Controllers Table of Contents Purpose ......................................................................................................................................................... 3 Communications Specifications .................................................................................................................... 3 Component to Component ........................................................................................................................... 3 Wiring ........................................................................................................................................................

4 Parameter Setup ....................................................................................................................................... 5 Slave Setup ............................................................................................................................................ 5 Master Setup ......................................................................................................................................... 6 Component to Component Using CX-Thermo ..............................................................................................

8 Wiring ........................................................................................................................................................ 8 E5CC Controller Settings ........................................................................................................................... 9 K3SC DIP Switch Settings ......................................................................................................................... 10 USB to RS-232C Cable (CS1W-CIF31) Settings ........................................................................................

11 Using CX-Thermo .................................................................................................................................. 122 Copying Parameters with the Master Device Online ........................................................................ 122 Copying Parameters with the Master and Slave Devices Online ...................................................... 221 Copying Parameters Starting Offline .................................................................................................. 31 Page 2 of 37

Стр. 2

Component to Component

Purpose Copying parameters between temperature controllers allows quicker change out and setup of multiple controllers. This can be done with component to component communications or using CX-Thermo in conjunction with other components such as an interface unit. This document will show how to copy parameters for the E5CC. This can also be done with other model numbers within the E5_C family, but some of the information might differ slightly, such as the wiring. Communications Specifications Figure 1: Communications Specifications Component to Component Both of the units must have communication capabilities, which is the 003 or 004 option selection for E5CC models.

Keep in mind that copy function is only possible between the same model number and the same version of the temperature controller. Page 3 of 37

Стр. 3

Wiring

Wiring Wire the controllers as follows for RS-485 communication. Figure 2: Communications Wiring Also wire additional inputs and outputs as needed for the application. Page 4 of 37

Стр. 4