Ref :UM-CT7-11-001 Issue : 01 Date : 28/04/2011 Page 25 of 35 7.2 PC-Link mode of operation To use the PC mode, you must: have installed the CT7 Console software (see 7.1 Installation,) run the CT7 Console program on PC, connect the CT7 with PC (USB cable) awake CT7 , activate PC‐link (para 6.4.1 PC Link) (With the left menu (LEFT) select SERVICE (DOWN ‐ DOWN); then select (RIGHT) and Enter the PC‐Link function. ) 7.3 CT7-Console reference The following screen appears (English version is implemented in the instrument): You should observe in the lower left corner of the PC screen the case “ connected/non-connected” shown as “connected”.
If this is not the case, push the button Connection to CT7 . There are four functions commanded by buttons in the upper left corner of the screen: About (A propos) Data handling (Gestion des donnйes) Measurements configuration (Configuration des measures) CT7 management (Gestion du CT7) This document is OPO property. It may not be either used or copied without authorization. OPO sprl, Crawhez 9, 4890 Thimister Clermont, Belgium. +32 87688989 - +32 87598990