Ref :UM-CT7-11-001 Issue : 01 Date : 28/04/2011 Page 8 of 35 4 CT7 Concepts 4.1 Quick Start. We recommend to calibrate CT7 after transport and when it is exposed to important temperature change. 4.1.1 Single measurement in brief In current use the measure sequence is following: Power up CT7 (Press joystick UP) Keeping it in hand , go to MEASURE option and trigger it. You have 5 seconds before the measurement starts. Place CT7 gently on the mirror. When the measurement is finished, and the results show‐up, pick up carefully CT7. Perform your measurements repeating the above steps.
Once in the office, connect to PC , run CT7‐Console and power‐up CT7, activate SERVICE/PC‐Link mode Retrieve data from CT7 to archive file. Sort data by date ,by cart, than export to Excel and finish your report with usual edition tools 4.1.2 Profesional work‐flow Install CT7 Console provided on CT7 Flash Disk on your PC, and start it. Connect CT7, awake it and activate SERVICE/ PC‐Link mode Indicate the COM port to be used (at first connection) Open Measurement Configuration Management Read Configuration from CT7 Edit table: selecting wavelengths to be used and give names to CARTs for specific mirrors . The CART name will help you to sort‐out the data for specific mirror.
Write Configuration to CT7 Disconnect by closing CT7‐Console. Now you are ready to monitor the mirrors. Select the active CART in menu MEASURE/ Sel. Cart. Perform your measurements following single measurement flow. Notes: You may always review results using menu Report/Data of CT7 This document is OPO property. It may not be either used or copied without authorization. OPO sprl, Crawhez 9, 4890 Thimister Clermont, Belgium. +32 87688989 - +32 87598990