Chapter3 Handling Horizontal Alignment This allows you to print an adjustment sheet for horizontal alignment. This allows you to adjust paper feeding when white or black banding/streaks appear on printouts. c IMPORTANT When printing the adjustment sheet, load paper that is 21.4 mm (0.84 inches) wide or more and 34.0 mm (1.34 inches) long or more. Printing the Horizontal Alignment Adjustment Sheet Continuous paper / continuous label If the paper width is 21.4 mm (0.84 inches) or more: 311.5 mm (12.26 inches) Printing an adjustment sheet with black mark detection still enabled may increase the amount of remaining paper required.
We recommend using settings where black marks are not detected, even for paper with black marks, when printing. Die-cut label (included roll paper) For the included roll paper, the adjustment sheet can be printed with three labels. Included roll paper: paper width 108.0 mm (4.25 inches), paper length 174.8 mm (6.88 inches), gap between pages 3.0 mm (0.12 inches) We recommend using continuous paper, continuous labels, or the included roll paper. The recommended length for printing the adjustment sheet on die-cut labels is 34.0 mm (1.34 inches) or more. When improving horizontal alignment, keep the printer settings unchanged from the settings you usually use.
Do not print adjustment sheet 1 Prepare print data that you can easily check banding or streaks on printouts. 210 Adjustment method Description Do not print adjustment sheet Select this method if you do not have die-cut label, continuous paper, or full-page label paper with a length of 66.7 mm (2.63 inches) or longer. Prepare print data that you can easily check banding or streaks on printouts, and then configure the settings by printing and adjusting repeatedly.
Print adjustment sheet Select this method to print a preset patterns for adjustment on die-cut label, continuous paper, or full-page label paper with a length of 66.7 mm (2.63 inches) or longer, and carry out the adjustment using the printed patterns.