Chapter3 Handling • Die-cut label (Gap) Leave a margin of at least 146 mm (5.75 inches) between the rear edge of the paper and the rear edge of the last ticket or label. Less than 146 mm (5.75 inches) from the rear edge of the paper should be liner paper only, with no labels. When the last ticket or label has been printed, the message shown below will be displayed and the printer will stop. Reload the paper to resume printing. Cannot detect the paper with the specified [Media Detect] setting. Load paper that matches the setting or change the [Media Detect] setting.
Edge of black mark Rear edge of the last label Paper feed direction Roll paper core 146 mm (7.80 inches) or more How to Process Fanfold Paper The following types/forms of paper can be used. • Continuous paper (Black Mark) • Die-cut label (Black Mark) How to process paper Leave a margin of at least 198 mm (7.80 inches) between the rear edge of the paper and the rear edge of the last ticket or label. Less than 198 mm (7.80 inches) from the rear edge of the paper should be liner paper only, with no labels. When the last ticket or label has been printed, the message "Fanfold paper is not loaded" will be displayed and the printer will stop. Reload the paper to resume printing.
Continuous paper (Black Mark) Die-cut label (Black Mark) Paper feed direction Rear edge of the last label 198 mm (7.80 inches) or more 295 Rear edge of the last ti Paper feed direction 198 mm (7.80 inches) or more 198 mm (7.80 inches) or more