Chapter3 Handling • Cleaning work should be performed under normal temperature environment. Under high temperature environment, rubbing alcohol may cause deterioration, discoloration, and cracking of the printer surface. • Do not spray rubbing alcohol directly on the printer or clean it with a cloth so damp that it drips rubbing alcohol. Also, do not allow rubbing alcohol to enter inside the printer through gaps in the buttons on the control panel and gaps in covers. If rubbing alcohol gets inside the printer, it may short-circuit the electronic components or cause deterioration or damage to the components. • Do not rub the printer surface strongly or wipe the same area repeatedly.
The printer surface may become deteriorated or damaged beyond repair. • Clean with rubbing alcohol no more than three times a day. • Do not connect the power plug or operate the power supply until the rubbing alcohol has completely dried. CAUTION Cleaning the Platen If there is ink adhered to the platen, hands or paper may become dirty. Furthermore, if the holes in the platen become blocked by dirt, ink soiling inside the platen may occur. Use the non-woven fabric or cotton swabs to clean the platen by following the steps below. • Do not use water or alcohol. • Take care not to change the position of the shutters on the platen.
If the shutters are opened or closed incorrectly, paper may get jammed or be smudged with ink. • Take care not to deform or damage the four sensors. CAUTION 1 Turn the printer off and then disconnect the power cable from the outlet. 2 Open the front cover. 301