Chapter3 Handling Cleaning the Auto Cutter The fixed blade of the auto cutter may become unable to cut cleanly due to the adhesive of label paper adhering to it. Perform cleaning by following the steps below. 1 Turn the printer off and then disconnect the power cable from the outlet. 2 Open the front cover and remove the paper. 3 Remove the adhesive adhered to the fixed blade of the auto cutter on the front cover side. • Do not directly touch the fixed blade of the auto cutter. Doing so may cause injury to a finger. • Do not use benzine, thinner, trichloroethylene, or ketone based solvent. Doing so may deform or damage the plastic and rubber parts.
• Do not spray or allow alcohol to drip directly on the printer. If alcohol gets inside the printer, it may short-circuit the electronic components or cause deterioration or damage to the components. • Be careful not to allow alcohol to come into contact with any sections beside the areas to be cleaned. CAUTION 303 wab or the like dampened w ith alcohol.