Chapter3 Handling Cleaning the Inside of the Printer (when Paper is fed from the Outside) When printing on label paper feeding it from outside the printer, the adhesive of the label paper may adhere to the inside of the printer, resulting in poor print quality. Please follow the procedure below to clean the printer. 1 Turn off the printer and disconnect the power cable from the power outlet. 2 Open the front cover. 3 Open the rear cover and remove the paper. 4 Remove any adhesive that has adhered to the inner surface of the fanfold paper guides. Use a cloth moistened with alcohol (recommended: ethanol 80 vol% or less).
5 Remove any adhesive that has adhered to the inner surface of the paper feed guide. Use a cloth moistened with alcohol (recommended: ethanol 80 vol% or less). • Do not press down hard on the paper feed guide. This may cause the paper feed guide to come off or be damaged. • Do not use benzine, thinner, trichloroethylene, or ketone based solvent. Doing so may deform or damage the plastic and rubber parts. • Do not spray or allow alcohol to drip directly on the printer. If alcohol gets inside the printer, it may short-circuit the electronic components or cause deterioration or damage to the components.
• Be careful not to allow alcohol to come into contact with any sections beside the areas to be cleaned. CAUTION 305