Chapter4 Information for Application Development Changing Printer Settings and Replacing Printer Follow the flowchart below. Connect the printer to a computer that is used for making the settings ( Page 20 , Page 53 ) USB Interface Ethernet Interface Connect the printer and the computer with a USB cable Connect the printer to the network Set the IP Address ( Page 52 ) Set the IP address of the printer to the address that has been set to the old printer using EpsonNet Config or operation panel of the printer.
Configure using PrinterSetting Configure the resolution of the printer and set to monochrome print mode ( Page 339 ) Change the resolution of the printer to the resolution of the ZPL II printer, and enable monochrome print mode. Register your background image ( Page 341 ) • Create the image • Register the image Register Fonts ( Page 343 ) • Obtain similar fonts • Register fonts and make replacement settings Adjust font width and object positioning ( Page 349 ) Print ( Page 352 ) • The background image is printed in color regardless of the monochrome print mode setting. • When adjusting, make the adjustment checking actual printouts. 338