Chapter 1 Product Overview Printing Status Sheet By printing the status sheet, you can check the firmware version and the current printer settings, such as print mode and media detection settings. On the operation panel, select the menu in the order shown below to print the report. [Menu] - [General Settings] - [Network Settings] - [Network Status] - [Print Status Sheet] c IMPORTANT • When printing the status sheet, load paper that is 101.6 mm (4.00 inches) wide or larger. • When printing the status sheet (Network settings), load paper that is 96.6 mm (3.80 inches) wide or more and 84.7 mm (3.33 inches) long or more.
Amount of Remaining Paper Required to Print a Status Sheet Continuous paper / continuous label If the paper width is 101.6 mm (4.00 inches) or more: 415.5 mm (16.36 inches) Printing a status sheet with black mark detection still enabled may increase the amount of remaining paper required. We recommend using settings where black marks are not detected, even for paper with black marks, when printing. Die-cut label (included roll paper) Included roll paper: paper width 108.0 mm (4.25 inches), paper length 174.8 mm (6.88 inches), gap between pages 3.0 mm (0.12 inches) For the included roll paper, the status sheet can be printed with three labels.
When printing the status sheet with die-cut labels, the amount of remaining paper required depends on the paper width, paper length, and gap between pages. Since some combinations require paper lengths of up to 1,544 mm (60.8 inches), we recommend using continuous paper, continuous labels, or the included roll paper. Amount of Remaining Paper Required to Print a Status Sheet (Network Settings) Continuous paper / continuous label If the paper width is 96.6 mm (3.80 inches) or more: 315.1 mm (12.41 inches) Printing a status sheet (Network settings) with black mark detection still enabled may increase the amount of remaining paper required.
We recommend using settings where black marks are not detected, even for paper with black marks, when printing. Die-cut label (included roll paper) For the included roll paper, the status sheet (Network settings) can be printed with three labels. Included roll paper: paper width 108.0 mm (4.25 inches), paper length 174.8 mm (6.88 inches), gap between pages 3.0 mm (0.12 inches) 34