Chapter3 Handling You can change the following settings; auto cut setting (the auto cutter model only), buzzer (notification) setting, pause setting, ink profile, ratio of black to composite, and ink drying time. For explanation of each setting, refer to the Help. If you print without selecting the check box for [Ink Profile], [Ratio of Black to Composite], and [Drying time per head pass], those settings configured on the printer are applied. The gray out settings shown on the driver screen are not showing the actual settings, but they are default settings of the printer driver.
CAUTION • You can change the driver's default setting of [Auto Cut] (the auto cutter model only), [Notification], and [Pause] following the procedure below. 1. From the Apple menu, select [System Preferences] - [Printers & Scanners]. 2. Select the printer, and then click [Options & Supplies] - [Option]. 3. Change the setting. • If you increase the ratio of black ink, be careful not to touch the label surface immediately after printing because ink can adhere to your fingers. • Cautions for when [Label length] is set to a value less than 15.0 mm (0.59 inches) • Auto cutting is not possible because a paper jam may occur.
• You can select all three [Cut] options below in [Settings For Paper HandlingAfter Print]. - Cut (after printing last label) - Cut (at specified label) - Cut (after last page of collate page) • If you have selected [Cut (at specified label)] for [Settings For Paper Handling After Print] and selected the [Collate] check box on the [Options] tab, specify the number of pages per copy in [Cut Interval]. If you have not selected the check box, we recommend specifying the number of copies in [Cut Interval].
• When [Settings For Paper Handling After Print] - [Cut (at specified label)] - [Cut Interval] is set to "1", the driver automatically changes [Cut Interval] to "2" to reach or exceed the minimum label length that can be cut (15.0 mm (0.59 inches)). Also, to ensure that the label length does not become less than the minimum label length that can be cut (15.0 mm (0.59 inches)), "1" can no longer be set for [Cut Interval]. 9 Check the print settings, and then click [Print] to start printing. 171 3 Extension Settings