Chapter2 Setup Installing the Printer Allow sufficient space for the printer. Make sure that the installation location meets the following requirements. • On a level and stable surface with sufficient strength to support the weight of the printer • On an area larger than the bottom surface of the printer. • A location that is not subject to vibrations and impacts. • A location where a dedicated power outlet is available. • A location where you can load and remove paper without difficulty. • A location with sufficient space around the printer to allow for installation of accessories, replacement of consumable products, and daily cleaning.
• A location that meets the following environmental requirements. For more details, see "Environmental Specifications" on page 399 . • Make sure to carry the printer by two or more persons. • To lift the printer, put your hands on the indented portions on the side of the printer as shown below. If you put your hands on the other portions of the printer to lift it, the printer may get damaged. CAUTION • Do not install the product at a location exposed to strong light such as direct sun rays. Doing so may result in printing failure due to malfunction of the detectors.
• If the printer has charged matte black ink and is more likely to be exposed to a temperature of -10 or lower degrees C (14°F), make sure to discharge ink before turning the printer off. Otherwise, the print head may be damaged due to freezing. For more details, see "Storing the Printer After Ink is Charged" on page 313 . 37 Auto cutter model Peeler model CW-C6000 Series Approx. 22.5 kg (49.60 lb) Approx. 22.8 kg (50.27 lb) CW-C6500 Series Approx. 25.5 kg (56.22 lb) Approx.
26.3 kg (57.98 lb) Temperature Humidity Printing 5 to 35°C (41 to 95°F) 20 to 80% RH, No condensation Storage Gloss black ink -20 to 40°C (-4 to 104°F) 5 to 85% RH, No condensation (without being unpacked) Matte black ink -10 to 40°C (14 to 104°F)