Chapter2 Setup How to Load Paper (Auto Cutter Model - Supply from Inside) After turning on the printer, do not open the paper cover until the home screen is displayed. Doing so may cause paper to be set improperly. CAUTION 1 Turn on the printer, and then check that [Internal] is selected as the [Media Source] setting on the operation panel. ( "Operation Panel Settings" on page 229 ) 2 Open the paper cover. 3 Remove the spindle from the printer. As shown in the figure, hold the spindle and flange with both hands, and remove them. 4 Load the roll paper on the spindle and fix it with the flange. • To move the flange, squeeze the two levers.
• When loading the roll paper on the spindle, take note of the winding direction. The correct winding direction is marked on the spindle. • Fix the flange and roll paper so that there is no gap in between. 51