Chapter 3 Commands 3 [Examples of command transmissions] Set the end print signal to "Normal: High, When feeding paper: Low". The ^JUS command must be used to save the settings to the non-volatile memory in the printer. An example of the command transmission is shown below. It is sent via USB or Ethernet from the computer.
^XA ^S(CNA,B,1 ^JUS ^XZ 25 Signal Printer status Signal status Sent label format Processed label format Standby for start signal Print label Ready to print next label Data preparation complete Preparing Preparation complete Start print Do not start Start End print Not finished Finished Signal Printer status Signal status Sent label format Processed label format Standby for start signal Print label Ready to print next label Data preparation complete Preparing Preparation complete Start print Do not start Start End print Not finished Finished Signal Printer status Signal status Sent label format Processed label format Standby for start signal Print label Ready to print next label Data preparation complete Preparing Preparation complete Start print Do not start Start End print Not finished Finished