Chapter 3 Commands Ink low signal (output) mode setting [Format] ^S(CNA,J,c [Parameter] c [Function] This sets the ink low signal mode setting. [Initial value] 3 0 [Examples of command transmissions] The ink low signal is set to the mode that is high in the normal status, and low when there is little ink remaining. The ^JUS command must be used to save the settings to the non-volatile memory in the printer. An example of the command transmission is shown below. It is sent via USB or Ethernet from the computer. ^XA ^S(CNA,J,1 ^JUS ^XZ 32 Description Definition range c = Mode setting D/E/0/1/2 Value for parameter c Description D/0 Turns the ink low signal (pin 8) OFF (not output).
1 Sets the ink low signal (pin 8) as follows: Normal: High, When there is little ink remaining: Low. E/2 Sets the ink low signal (pin 8) as follows: Normal: Low, When there is little ink remaining: High.