Appendix Fanfold Die-cut Label (Black Mark) Paper feed direction Label area Paper 2.0 mm {0.08 in.} or more Corner R Black mark Black mark width 377 Release liner width Perforation Cut Uncut Gap between labels Label length Black mar length Waste part Label width R rk e part Label width Item Specifications Paper Type Plain paper, Matte paper, Synthetic paper, Glossy paper, Glossy film, High glossy paper, Texture paper Release liner width 50 to 112 mm {1.97 to 4.41 in.} Label width 46 to 108 mm {1.81 to 4.25 in.} Label length 8 to 301.8 mm {0.31 to 11.88 in.} Auto cut is not possible when the length of the paper is less than 15 mm {0.59 in.}.
Gap between labels 3 to 6 mm {0.12 to 0.24 in.} Waste part on both sides 2 ± 0.5 mm {0.08 ± 0.02 in.} Label corner R 1.5 mm {0.06 in.} Black mark position See the above figure.
Leading edge of the mark should be aligned with that of the label Black mark width 19 mm {0.75 in.} or more Black mark length 4 to 25.4 mm {0.16 to 1.00 in.}, with 4 mm {0.16 in.} or more of space around the mark Black mark interval 11 to 304.8 mm {0.43 to 12.00 in.} (When auto cutting is not performed) 18 to 304.8 mm {0.71 to 12.00 in.} (When auto cutting is performed) Pap er thickness 0.159 to 0.240 mm {0.006 to 0.009 in.} Fold interval 152.4 to 304.8 mm {6.00 to 12.00 in.} Number of folds 750 or less Perforation form 3 to 5 mm {0.12 to 0.20 in.} of slit length with 1 mm {0.04 in.} interval * There should be no slits at both side edges of paper Holes and cutouts Paper with holes or cutouts cannot be used