Appendix Allowable Tag Holes Dimensions by Distance from Paper Reference Line The allowable dimensions of holes and oblong holes for paper detection depend on the distance (X) from the reference line of the paper. The allowable dimensions of cutouts do not vary depending on the distance from the paper's reference line. * The shortest distance from the edge of the hole or oblong hole to the paper reference line. ❏ Hole (for paper detection) Reference line 381 Distance (X) from Paper Reference Line* (unit:
mm/inch) 0 ≤ X ≤ 1.35 (1) 1.35 (2) 4.6 (3) 10.9 Detection setting Dimensions -- Min Max Min Max Min Max Hole Diameter (Φ) No holes allowed here 3/0.12 3.5/0.14 3/0.12 9/0.35 3/0.12 12.7/0.50 Oblong hole Paper feed direction (L) No holes allowed here 3/0.12 3.5/0.14 3/0.12 9/0.35 3/0.12 12.7/0.50 Paper width direction (W) No holes allowed here 3/0.12 4.6/0.18 3/0.12 12.7/0.50 3/0.12 12.7/0.50 Cutouts Paper feed direction (L) 3/0.12 3/0.12 3.5/0.14 3/0.12 3.5/0.14 3/0.12 3.5/0.14 Paper width direction (W) 4.35/0.17 4.35/0.17 6.35/0.25 4.35/0.17 6.35/0.25 4.35/0.17 6.35/0.25 0 mm {0.00 in.} Paper feed direction 1.35 mm 4.6 mm 10.9 mm {0.05 in.} {0.18 in.} {0.43 in.} (1) (2) (3) X here.
allowed holes Φ No ference the No holes allowed here. X is a distance from the paper re line to the top of hole shown by dashed line fere the nce