Chapter2 Setup Installing the Printer Allow sufficient space for the printer. Make sure that the installation location meets the following requirements. • Level, stable flat surface strong enough to support the weight of the printer (approx. 35.0kg {77.16 lb}).
• Flat surface larger than the area of the bottom of the printer • A location free from vibration and shock • A location where a dedicated power outlet for the printer is available • A location where paper can be set and removed without difficulty • A location where there is enough space around the printer to install accessories, replace consumables, and perform routine maintenance without difficulty • A well-ventilated location with at least 10 cm {3.94 in.} clearance from the air vent on the right side of the printer • A location that meets the following environmental requirements. For more details, see "Environmental Specifications" on page 393 .
If the printer has installed matte black ink and is likely to be exposed to temperatures below −10°C {14°F}, be sure to drain the ink before turning off the printer. Otherwise, the print head may be damaged due to freezing. For more details, see "Storing the Printer After Ink is Charged" on page 298 . CAUTION 45 Temperature Humidity Printing 5 to 35°C {41 to 95°F} 20 to 80% RH, No condensation Storage With gloss black ink −15 to 40°C {5 to 104°F} 5 to 85% RH, No condensation (without being unpacked) With matte black ink −10 to 40°C {14 to 104°F}