5 XF 95 series Removal and installation REPAIRING WIRING For each contact a specific ejector tool is required. The proper ejector tool for each contact can be found through ‘Parts Rapido’. An MQS (Micro Quadlock System) contact lock Before the contact can be removed, the lock must be unlocked with a needle-shaped object. 1 1. First press the lock at the end of the connector (1). At the same time gently pull the wire (2) until resistance is felt. 2. Then press the second lock (3) and again gently pull the wire (2). 3 3. The contact can now be removed from the connector. 3 2 Note: This type of contact is locked twice and must therefore be unlocked twice. E501486 Application examples:
- Connector for VIC electronic unit Removing contacts from the Bosch 89-pin connector To remove a contact from this connector proceed as follows: 1. Fold the protective cover around the wiring harness down by pushing the lock outwards. 2. Now push the two outer halves of the protective cover outwards and then upwards. The protective cover can now be removed. 1 3. The pink secondary contact lock (1) must be slid to the centre of the connector to enable the contacts to be removed. E501485 4. The contacts can now be removed using the proper ejection tool. 200303 2-5