Remote controller installation procedure Deciding where to install the remote controller Select the installation location based on “Safety Precautions” (see page 2) and obtain consent of the customer. Creating a wiring through-hole in the wall (when opening a hole in the wall and installing) [Unit : inch (mm)] 3-11/64 (80.5) Back plate Through-hole 13/64 (5) R3/32(2.5) 3-11/64 (80.5) 9/32 (7) Access hole Back plate Through-hole Access hole 35/64 (13.75) Align the centre of the wall hole with the centre of the access hole on the controller back plate when planning the installation.
13/64 (5) 41/64 (16.25) NOTE 33/64 (13) R3/32(2.5) If the hole size is too large or not in the proper location, it may be seen after the remote controller is installed. CAUTION • Note that if the wiring through-hole is large or deviates from the specified position, the hole may be exposed. 4 1-47/64 (4 1-47/64 (