Datasheet CP2000 690V Programming Group 00-xx Drive Parameters Drive ID, Software version, Password, Parameter reset, Control Mode, HD/ND/LD selection, User-defined display, Carrier frequency, Source of frequency/operation, Stop method, Motor direction inhibit, etc. Group 01-xx Basic Parameters V/f-curve (2), Max/Min Voltage and frequency, Acc/Dec times, Jogging, S-curve, 3 Skip frequencies, etc. Group 02-xx Digital Input/Output Parameters 2-3 Wire operation, Function and setting of digital inputs, outputs and relay, Count values, Debounce time, Brake delay, etc. Group 03-xx Analogue Input/Output Parameters Function, Gain, Bias, Filtering of analogue inputs and outputs.
Group 04-xx Multi-step Speed and Position 15 Speed steps and positions. Group 05-xx Motor Parameters Setting of motor parameters (2 motors), Auto-tuning, Slip compensation, Torque boost, Y- switch-over, Motor operation time, etc. Group 06-xx Protection Parameters Protection settings, Fault memory and conditions, PTC, etc. Group 07-xx Special Parameters Brake level, DC-Braking, Power loss override, DEB, Speed search, Auto reset, Fan control, Emergency stop, Auto Energy Saving, AVR, Slip compensation, Autorestart, etc. Group 08-xx PID Control Parameters PID settings, Sleep function, etc.
Group 09-xx Communication Parameters Protocol, Address, Transmission speed, Block Transfer, CANopen, Fieldbus settings, etc. Group 10-xx PM motor settings Current command, Observer, Angle, etc. Group 12-xx Pump parameters: Circulative control Settings for circulative control (cascading). www.delta-emea.com DELTA ELECTRONICS, INC. 21 of 21 Delta reserves the right to make ALL RIGHTS RESERVED changes without prior notice