Appendix Environmental Specification 1: After the vibration is applied, there should be no visible defect on both the surface and inside, and have no problem for operation. 2: After the impact is applied, there should be no visible defect on both the surface and inside, and have no problem for operation. 3: After the impact is applied while the product is not operating, there should be no visible defect on both the surface and inside, and have no problem for operation.
56 Operating Temperature / Humidity Storage 5 to 45°C {41 to 113°F}, 10 to 90% RH, non condensing, 34.0°C {93.2°F} of wet-bulb temperature (The blue area on the graph below shows operating environment) -10 to 50°C {14 to 122°F}, 10 to 90% RH, non condensing, 39.0°C {102.2°F} of wet-bulb temperature 90 80 60 40 20 10 0 0 10 20 30 40 50 Operating Vibration resistance*1 Before unpacking Frequency 10 to 150 Hz Acceleration rat Approx. 4.9 m/s2 {0.5G} Sweep 10 minutes (one way) Time 1 hour Directions XYZ Frequency 10 to 55 Hz Acceleration rate Approx.
19.6 m/s2 {2G} Sweep 10 minutes (one way) Time 1 hour Directions XYZ Before unpacking*2 Impact resistance After unpacking*3 Packaging specification Epson standard packaging for factory shipment Height 90 cm Directions 1 corner, 3 ribs, 6 surfaces Height 5 cm Directions 4 sides, Supporting only one side Life Product life 5 years LCD back light 43,800 hours or longer (the time until the brightness drops to half in a room temperature, 25 degrees C) Altitude 3,000 m or less