Using Windows NT 4.0 Installing Windows NT 4.0 Note If your Notebook came with an ESS soft modem, SETUP.EXE will also install modem drivers. 2. Follow the instructions on the screen to install the drivers. The drivers will be installed after the system reboots. To install pointing device support If you’ve installed a retail version of Windows NT, you can install pointing device support. The integrated pointing device(s) is fully supported by the Synaptics Touchpad driver. With the standard PS/2 mouse driver the integrated pointing device(s) will function, but will be without most special features. The touchpad files are located on the Recovery CD under \HP\DRIVERS\NT4\Touchpad. 1.
Run SETUP.EXE from the \HP\DRIVERS\NT4\Touchpad subdirectory. 2. Follow the instructions and restart to complete the installation. For more detailed information about the touchpad drivers, see the readme.txt file in the touchpad directory. To install IDE support Windows NT 4.0 installs a generic IDE Controller device driver. To increase performance, install the Intel PIIX4 PCI Bus Master IDE Controller driver that’s in the \HP\DRIVERS\NT4\PIIX4 directory on the HP Notebook Recovery CD. 1. From the Control Panel, double-click on the “SCSI Adapters” icon. 2. Click on the folder tab labeled “Drivers”. The currently installed SCSI adapter drivers will be listed in the Drivers menu. 3.
Select the default driver (“IDE CD-ROM (Atapi 1.2)/Dual-Channel PCI IDE”) Then, click on the “Remove” button to remove the driver. 4. Click Yes to Confirm. 5. Click “Add...” to add a new driver. 6. From the “Install Driver” dialog box, Click on the “Have Disk” button. 136 Corporate Evaluator’s Guide