Downloaded from https://www.everyspec.com LI W W 1/2 ORD. GO GAGE WEAR ALLOWANCE 4 -•, 1/2 ORO. GO GAGE TOLERANCE *W A1/2 WORK GO GAGE TOLERANCE lot1/2 TOTAL GO GAGE TOLERANCE T_ 34 gэ T1/2 ;EFFECTIVE TOL. AO PRuiu P1/2 TOTAL NOT GO GAGE TOL.N en ~ 1/2WORD NOT Go G ETL * ` - 1 / 2 WORK. NOT GO GAGE TOL. "2 .e| .oo5- IVY ME[ASUREM4•!T IQ allowance on the Ordnance NOT GO gage, since ment on the permitted tolerace aone by Ordl- K 'parts should not enter or be entered. In addi- nance gages, work gages normally are dimen- tion, any wear will take the gage further into the sloned and toleranced within the limits d thetoeac oepr~tdb h rwnad Odac aetu ute euigtetl Figure 5-29.
Efffect of gage tolerances ow couponewt toleramce T IS ~thus give more assurance that nonconforming erance zone available for the actual producer S~parts will not be accepted by the gage. It will of the parts. However, no wear allowance, ua- ~also be noted that In addition to the encroach- such, Is applied on the work GO gages. pat shudntetro eetrdsnad- nneggs okggsnral r ie-s tion an wer wll ake he agefurherint the Mond ad tlernco witin he imis o th