The increment of radius between threaded steps is such that each threaded sector of the breechblock will engage a corresponding sector in the process, but has clearance in the adjacent sector; hence, rotation of the breechblock through an angle equal to one sector serves to lock it, or disengage it for withdrawal. Thus, on a breechblock having three stepped sectors (two-threaded) in each quadrant, nearly two-thirds of the circumference is threaded, and rotation of slightly more than 30 degrees is needed to lock or unlock.
Downloaded from https://www.everyspec.com (a) The screw-type firing mechanism (see Figure 3-9) includes an externally threaded cylindrical firing mechanism block, having a socket holder at the forward end to support the base of the primer case, and a firing pin behind the socket. The block is seated in a threaded recess in the rear of the breechblock. To load, the firing mechanism block is unscrewed and removed manually from the breechblock (a radial arm with knob facilitates the operation), and the primer is inserted into the holder of the firing mechanism block. Then the block and primer are inserted into the breechblock as a unit, thus seating the primer in its chamber.
The block latches when fully screwed in. Firing is effected by a pull on a lanyard attached to a hammer pivoted on a bracket on the breechblock, the hammer striking the firing pin to drive it against the primer. The firing mechanism block is again removed, thus withdrawing the attached primer case, and the empty case is manually re- moved from the socket. Suitable interlocks prevent insertion or removal of the firing block, or impact of the hammer on the firing pin, while the gun breechblock is not fully closed or locked.
In current weapons with plug-type closures, ig- nition of the propellant is effected by use of a cannon primer, resembling in appearance a small arms blank cartridge, and which is chambered in the rear portion of an axial bore piercing the obturator spindle. The primer, when fired, dis- charges hot gases through the spindle into the gun chamber. The primer is fired by either a percus- sion mechanism, an electrical circuit, or a combined arrangement enabling use of either percussion or electrical firing. (Electrically fired primers are fired by heat generated in a resistive conductor element within the case when an electric current is passed through it.
Percussion primers are fired by a sharp blow of a firing pin on a primer cup containing a sensitive mixture, the mixture being thereby crushed against a firm metal face termed the anvil.) Firing mechanisms, or firing locks, used for insertion, rear support, firing and removal of the primer cartridge case after firing include screw- and sliding-block or sliding-wedge types as follows: 3-5.2.2.1.3 Ignition Figur« 3-10. Cannon Firing Lock, Electric or Percussion Ignition, Sliding-wedge Typo (b) One sliding-block type of firing lock is shown in Figure 3-10 and consists of a small sliding-wedge mechanism attached to the rear of the gun breech- block.
Its housing provides a longitudinal opening for insertion and withdrawal of the primer and supports a sliding block, which is moved trans- Figure 3-9. Percussion Firing Mechanism for Cannon, Scrmw-typm