Downloaded from https://www.everyspec.com from the grip of the extractor and throw it from the receiver as the bolt moves rearward. Bolts may be classified as nonlocking, locking, or delayed action, in accordance with the method of operation. 3.5.2.2.2.1 Nonlocking Bolts (Blowback) While not widely applied, bolts that do not lock in the closed position have functioned reasonably satisfactorily in some automatic and semiautomatic weapons using relatively low power ammunition.
In this method, the rearward pressure of the pro- pellant on the cartridge case impels the bolt through its rearward travel, but the weight of the bolt is such that inertia delays the'movement so that the projectile has left the gun muzzle before the breech is unsealed. In its rearward movement the bolt compresses a spring that returns the bolt to closed position to complete the cycle. To interrupt the firing, release of the trigger permits a sear to retain the bolt in retracted position. Figun 3-13.
Bolt-type Breech Closure {Automatic Gun), Nearing fv/f Opening, Ejecting Fired Cam movement (parallel with the gun bore) of the bolt, a sliding component variously shaped, but generally elongated in the direction of motion. At closed position, the bolt blocks, but does not seal, the rear opening of the chamber; to open, it is moved rear- ward sufficiently for extraction of the fired case and insertion of the next cartridge. Forward move- ment then seats the cartridge in the chamber. Obturation is provided by expansion of the car- tridge case against the chamber wall by propellant pressure. Movement of the bolt is guided and confined by a housing and support component tunned the receiver.
Percussion firing of the car- tridge is effected by a firing pin carried within the bojt and actuated by a spring or spring-loaded hammer, controlled by manually operated sear-and- trigger mechanism, or automatically released; or by inertia of the pin (and other weights sliding with it) as the bolt is stopped at the end of forward travel. Electrically primed cartridges are fired by the closing of an electrical circuit that includes an insulated firing pin. Where used, the firing spring is compressed by the movement of the bolt, a typical arrangement comprising a cocking lever pivoted on the bolt and actuated by a cam surface in the re- ceiver.
Withdrawal of the fired case is effected by an extractor (hook or equivalent rim) on the bolt front end, which engages the rim or groove at the base of the cartridge case to draw the case as the bolt moves rearward. Ejection of the empty case is accomplished in some automatic mechanisms by lateral displacement by the incoming cartridge; in other designs a spring-loaded ejector lever on the bolt or in the receiver presses or strikes the base of the cartridge off center to tilt the case free Bolts are locked in position by various means. Typical methods used include:
rotation of the bolt through a small angle as it completes forward travel, to engage corresponding lugs, or lugs and grooves, on and in the bolt and receiver; tilting of a member hinged to the bolt, to engage a recess in the receiver as the bolt reaches closed position; lateral or vertical movement of a bar carried in a rearward extension member attached to the barrel, to engage a recess in the bolt; and slight tilting of the barrel to effect engagement of ribs on the rear end of the barrel with grooves in a forward exten- sion of the bolt. 3-5.2.2.2.2 Locking Bolts Not in current use in U. S.
Army weapons, the delayed action bolt lock was formerly employed in some automatic weapons to prevent excessive ra- pidity of fire. These arrangements provide no positive lock of the closure; they permit the bolt to be moved rearward by propellant pressure, but delay the movement by forcing the pressure to over- come a mechanical disadvantage other than inertia. Delayed action bolts include: 3-5.2.2.2.3 Delayed Action (Hesitation) Bolts (a) Crank-type. The bolt is linked by a con- necting rod to a crank pivoted in the receiver, so that reciprocating movement of the bolt produces oscillation of the crank. At closed bolt position, 3—10