US Army Materiel Command AMCP 706-250 — AMCP 706-250 Guns—General Engineering Design Handbook (1964) PDF (EN)

Downloaded from https://www.everyspec.com a threaded cylindrical breechblock screwed into a cylindrical, internally threaded recess in -the breech ring. The block diameter exceeds twice that of the chamber, and its axis of rotation, parallel to the chamber axis, is below the circumference of the chamber opening. A deep U-shaped groove is cut from back to front of the block to provide a channel for insertion of the ammunition. Rotation of the block through approximately a /fc revolution then covers the base of the cartridge, the pitch of thread advancing the block to fully seat the cartridge.

At the closed position the percussion firing pin, housed in the breechblock diametrically opposite the loading channel, is in line with the chamber axis, in position to strike the primer when driven by the firing hammer. When the reverse rotation is applied to open the breech, a forked extractor lever, pivot-supported in the breech ring, is actu- ated by a cam groove in the forward face of the breechblock to extract and eject the cartridge case as the loading channel reaches alignment with the chamber. until stopped by manipulation of a control device by the operator or by failure of the ammunition supply.

The energy for operating the mechanism to eject the empty case and insert and fire each U successive round is derived from the firing of the ^ preceding round. Preliminary insertion of the first round and cocking of the mechanism to fire the first round are accomplished by moving the mechanism through a portion of its cycle by hand or other outside power. The term automatic is sometimes erroneously applied to firearms that are not fully automatic; e.g., those requiring a manual trigger pull to fire each round, the remaining portion of the cycle being automatic.

3-6.3 Semiautomatic This term is somewhat loosely applied to guns in which some portions of the cycle of insertion of ammunition, closing, firing, opening, and ejection of fired cases are automatically accomplished, and the remainder are performed manually or by ex- ternal power manually controlled, In the field of small arms and cannon of relatively small bore, the term semiautomatic generally indicates that the mechanism, on firing a round, operates automati- cally through the functions of opening, ejection and insertion of the succeeding round, but does not fire the latter round unless the trigger or other firing control is again manipulated by the operator.

In reference to cannon in general, the term may indi- cate automatic functioning through some smaller portion of tne complete cycle. A typical example is the medium caliber gun with vertically sliding breechblock, in which breech opening, ejection of the case, and cocking of the firing mechanism is accomplished through cam action during counter- recoil movement of the cannon. The breech then remains open (locked by the extractors) but closes automatically when a round is inserted into the chamber with sufficient force to strike and unlock the extractors. The firing mechanism remains cocked after the breech closes and is released to fire the round only by separate action of the operator.

The large size and weight of the breechblock and breech ring necessary for this type of closure is an unfavorable factor where space and weight limita- tions are important. 3-6 Classification by Degree of Self Action Guns may be classified in this manner as (a) manual, (b) automatic, and (c) semiautomatic. 3-6.1 Manual This term indicates a type of gun in which the energy required to operate the breech mechanism through the movements necessary for loading, closing, firing, opening and case ejection is sup- plied by the operator.

If the mechanism is designed for insertion of multiple rounds and successive feeding, positioning and firing of these rounds by manual operation of the mechanism, the weapon is termed a repeating type; if each successive round must be manually inserted into the mechanism after the previous one has been fired, the weapon is termed a single shot type.

3-6.2 Automatic The term applies to firearms in which the mecha- nism, after firing is initiated by the operator, ex- tracts or is fed successive rounds from a belt, hop- per, or other suitable source, and continues to fire 3-7 Classification by Source of Power Operation Such classes include (a) externally powered, (b) gas operation, (c) recoil operation, and (d) blowback. 3—14