US Army Materiel Command AMCP 706-250 — AMCP 706-250 Guns—General Engineering Design Handbook (1964) PDF (EN)

Downloaded from https://www.everyspec.com CHAPTER 4 GUN INTERIOR REGIONS AND CHARACTERISTICS 4-1 Major Divisions and General Functions as a portion of the propellant's working expansion space. Pertinent factors include the energy re- quired to be transmitted to the projectile; the maxi- mum propellant pressure permitted in the gun structure; the rate of reduction and total reduction of propellant pressure as the projectile advances through the bore to the muzzle; and the quantity of propellant to be burned to impart the required velocity to the projectile and supply all losses.

(The losses include projectile engraving, friction, acceleration of gases, acceleration of the gun in recoil, heat lost to the gun, gas leakage, and heat remaining in the propellant after the projectile emerges from the gun muzzle.) The interior of a gun tube (Fig. 3-1), with a few exceptions noted below,* may be considered to con- sist of three general divisions, identified by use or function as follows: a. The chamber: The inclosed space in which the charge of propellant is placed and ignited to generate pressure for driving the projectile. b. The bore: The passage through which the projectile is driven by propellant pressure.

The bore provides confined space for expansion of the propellant gases during acceleration of the projec- tile and guides the projectile to exit.* c. The transition region: The connecting pas- sage between the chamber and the bore, with con- tours designed to insure correct entry of the pro- jectile into the bore and to provide such sealing surfaces against the projectile and cartridge case as are required to prevent leakage of propellant gases. For a given quantity of propellant, the chamber size may be varied somewhat to obtain desired modifications in the shape of the pressure-travel curve. (Typical pressure-travel curves are shown in Fig.

5-1 and are discussed in Chapter 5.) In current practice, however, the density of loading (number of grams of propellant per Јubic centime- ter of chamber capacity) is generally limited to a maximum of 0.75 for cannon, and 1.0 for small arms, to avoid the increase of pressure variation resulting from small differences in loading density when the above figures are exceeded. Reduction in loading density has a reducing effect on the maximum pressure produced, but extremely low loading densities also tend to induce nonuniformity of maximum pressures.

Hence, both extremes are avoided wherever practicable, in order to limit round-to-round velocity variations to those result- ing from unavoidable variations in gun and ammu- nition manufacture, or those occasionally resulting from abnormal and unpredictable circumstances encountered in service. 4-2 Chamber Characteristics (References 5, 9 and 12) 4-2.1 Size of Chamber The volume to be provided in the chamber is based on its service as a combustion chamber and * Because of the coaxial positions and continuity of the inclosed space of the chamber, transition region, and bore, the term bore is sometimes used to denote the entire interior of the tube or barrel.

However, the restricted meaning indicated in b. above is preferred, except in reference to certain designs typified by the muzzle-loaded gmooth-bore mortar. In such mortars the chamber and the projectile- guiding portion of the bore are merely zones of a uniform cylindrical bore, and no transition region is needed. For this type of weapon the transition features described in subsequent paragraphs do not apply, and variations in chamber proportions are practically limited to the varia- tions in length that may be made without excessive de- parture from optimum chamber volume.