Downloaded from https://www.everyspec.com IA trant angles. Forgings and castings are less tlhrough heat treatment. Those members of 9 susceptible to warpage than weldments al- the cradle which require finished surfaces are though all should.be stress relieved to insure made oversize so that residual irregularities dimensional stability. The main disadvan- may be removed when the part is machined tages of castings include bulkiness and a to size. lengthy manufacturing process. Welded as- semblies should be used where applicable. D. MAINTENANCE The built-up structure is relatively simple and light. Joints are permanent, providing a more 57.
A well designed structure embodies good rigid structure than if bolted or riveted. maintenance features; hence ease of main- Weldments can be made from available stock tenance, both preventive and corrective, begins material permitting construction at low cost on the drawing board.* Inspecting, cleaning, in a relatively short time. Although weld- and lubricating are activities usually associated ments are prone to warp, this tendency is over- with preventive maintenance, with lubrication come by ress relieving through heat tv-eat- being the most important because it not only byment.
reduces friction and the accompanying wear or galling but it also protects the sliding sur- faces from corrosion. A good lubricant for B. SUGGESTED MATERIALS FOR CRADLE sliding s4rfaces is Spec MIL-G-10924A grease 55. The predominant requirements for the which lubricates effectively through the tem- cradle are strength and rigidity. For its main perature range of -65* to 125*F. Lubrication structure, an inherently strong material with a should be a simple task requiring only a short high modulus of elasticity is preferred. This time to perform.
Therefore, fittings must be suggests steel although it does not exclude readily accessible ol the assembled weapon other materials having the required physical but should not be located in highly stressed re- properties. For the sliding surfaces, hardness gions of the cradle because small holes cause and compatibility are necessary, hardness to stress concentrations. If this is unavoidable, 1 preclude scoring and compatibility to preclude then the lubrication holes should be heavily galling of the contacting surfaces. Steel slides, bossed for reinforcement. rails, and guides, as components of the main 58. A cradle functions best when clean.
structure, provide strength ard rigidity and, as Any dirt or other foreign substance on slides sliding members, provide a hardened surface. or trunnions will impede recoil and elevation. Hard bearing bronze, covering one member, Maintenance here means continuous effort in also provides a hardened surface and, in con- keeping the cradle and its attachments clean. junction with the bare steel of the other mem- Sand, mud, water, snow, or ice must not ac- ber, constitute two adjacent materials which cumulate in it. Pockets created by structural can provide the compatibility requirement.
members should have drain holes or should be Bronze is preferred to brass because of the easily reached for cleaning, otherwise water, tendency of the latter to form zinc oxide, a from rain or melting snow, accumulating in substance that promotes galling, these pockets may later freeze and damage even otherwise well designed equipment. Dirt must be kept off sliding surfaces. Cover plates C. MANUFACTURING, PROCEDURES are effective seals at the trunnion. Wipers, 56.
Standard prcduction practices are fol- located where the initial contact begins be- lowed in constructing cradles regardless of tween sliding surfaces, remove dirt and grit whether castings, forgings, or weldments form from the exposed portions of the slides. the basic structure. If this practice deviates, 59. Corrective maintenance is a repair or re- it is only in handling. 'Basic fabrication activi- placement activity which may require the dis- ties remain undisturbed. If necessary, ma- assembly of the cradle. In many instances this chines are adapted for convenient operation. *The subject of maintenance is covered in detail Warpage is corrected by stress relieving in Reference 8. 22 I