US Army Materiel Command AMCP 706-341 — Engineering Design Handbook — Carriages and Mounts Series: Cradles (EN)

Downloaded from https://www.everyspec.com Rt FA 1 --- 50 0 --- 4 25 O -0 RP L 32.0 t Ra F , A)GAL AND NOWAL RE&TIONS ON TRUNNIONS to .it FRICTIONAL FORCES ON FRONT AND REAR BEARINGS H, & HORZONTAL AND VFERTI.AL FORCES OF CRDLE MASS R 6 .RT: VERTICAL LOADS DUE TO RECOIL ROD OFFSET Ki RECOIL ROD FORCE R,RintR HORIZONTAL AND VERTICAL LOADS OF ELEIrlNG ARC Rj,R 2 t NOWAL LOADS ON FRONT AND REAR 9EARINGS Figure 24. Cradle Body Showing Applied Loads and Reacions J) Shear and Moment Chart Station x V XV H y M.

M, M 75 0 -469 -469 70 7 0 49 49 25 50 -69 -538 6 0 2345 0 2394 22 3 332 -206 0 161 2555 12 -388 10 -388 2373 0 12 438 232 -1118 0 247 0 2620 -5 5 1885 2117 -116 2504 -5 44 7 -31 2473 12 10 0 -206 206 2961 -7.5 2.5 0 2117 -529 1944 -1 2.5 -527 1590 0 -529 1415 -11.3 1.28 -1590 0 1386 8.78 -204 -1218 -7 Units of x and y are given in inches; V, ZV and H in 100 1b; M,, M, and M in 1000 lb-in. To resume the analysis, assume the cylinder Mc 2,761,000 X 7.75 32 4 to have an ID of 14.5 inches and an OD of T 7 - 662 15.5 inches. The area is IV 211,700 = 9,000 lb/in' (not critical) A = 52 - -.

52) = 23.56 in 2 With the material having a yield strength of The moment of inertia is 60,000 lb/in, the bending stress shows a factor of safety of almost 2, thus making a wall of 94-I = -5 - .5') = 662 in' -1-inch thickness more than ample for the gen- eral bending stresses. However, local stresses The bending and shear stresses are present another problem and the wall must be 27 255-012 (8040A) 0 - 67 - 3 If, r