US Army Materiel Command AMCP 706-117 — Environmental Series, Part Three: Induced Environmental Factors (EN)

Downloaded from https://www.everyspec.com AMCP 7-117 TABLE OF CONTENTS (con.) Paragraph Page 3-2.3.3 Size Distribution Associated with Aircraft .......... 3.9 3-2.3.4 Size Distribution vs Altitude ................... 3-9 3-2.4 Particle Shape ............................ 3.12 3.2.4.1 General 3..........................312 3-2.4.2 Particle Shape Factors. .................. 8-12 3-2.5 Composition and Hardness .................... 3-12 3-3 Measurements ..... ....................... 3.13 3-3.1 Sampling Methods ..... .................... 3.13 3-3.2 Particle Size Analysis ........................ 3-16 3-3.2.1 Means of Separation ........................

3-16 3-3.2.2 Correlation of Data From Different Methods ...... .3.17 3-3.2.3 Instrumentation .......................... 3.17 3-4 Factors Influencing the Sand and Dust Environment ............................ 3-17 3-4.1 Terrain ....... .......................... 3.18 3-4.2 Wind ...... ........................... 3.18 3-4.2.1 Pickup Speed ...... ...................... 3.20 3-4.2.2 Typical Windspeeds ....................... 3-20 34.2.3 Vertical Distribution ........................ 3-20 3-4.3 Humidity and Precipitation ................... 3.-21 3-4.4 Temperature ..... ....................... 3-21 3-5 Effects of Sand and Dust ......................

3-21 3-5.1 Errosive Effects ........................... 3-21 3-5.1.1 Erosion ...................... ......... .3-21 3-5.1.2 Abrasive Wear of Mechanisms ................. 3-23 3-5.2 Corrosive Effects ....................... 3-23 3-5.2.1 Chemically Inert Particles .................... 3-25 3-5.2.2 Chemically Active Particles ................... 3-25 3-5.3 Electrical Insulators ......................... 3-27 3-5.4 Electrical Cortacts and Connectors ............... .3-29 3-5.5 Electrostatic Effects . . ' .................... 3.29 3-5.6 Guided Missile Operation ..................... 3-30 3-5.7 Effects on Visibility ..... ................... 3-30 3-5.8 Other Effec~s..... ........................

3-30 3-6 Sand and Dust Protection .................... 3.31 3-7 Design and Test ...... ...................... 3.31 3-8 Test Facilities ..... ....................... 3-32 3-8.1 Simulation Chamber ..... ................... 3-32 3-8.2 Desert Teu: Ing Facilities .................... 3.33 References .............................. 3-33 CHAPTER 4. VIBRATION 4-1 Introduction ............................. 4-1 4-2 Sources of Vibration ......................... 4.3 4-2.1 Vehicular Vibrations ........................ 44 4-2.1.1 Road Vehicles ............................ 44 iii