For example, :MASK:SOURce CHANnel2 /*Set the measurement source of the pass / fail test to CH2*/ :MASK:SOURce? /*The query returns CHAN2*/ :MASK:OPERate For example, :MASK:OPERate RUN /*Run pass / fail test function*/ :MASK:OPERate? /*The query returns RUN*/ :MASK:MDISplay For example, :MASK:MDISplay ON /*Open statistics*/ :MASK:MDISplay? /*The query returns 1*/ :MASK:SOOutput 41 / 136 Discrete {CHANnel1|CHANnel2|CHANnel3|CHAN nel4} CHANne l1 Description This command can only set the channels that have been opened. You can send the: CHANnel : DISPlay command to open the required channels. Return format The query returns CHAN1, CHAN2, CHAN3, or CHAN4.
Command format :MASK:OPERate :MASK:OPERate? Function description Run or stop the pass / fail test, or query the running status of the pass / fail test. Parameter Name Type Range Default Discrete {RUN|STOP} STOP Description Before executing this command, you need to send the: MASK: ENABle command to enable the pass / fail test function. Return format The query returns RUN or STOP. Command format :MASK:MDISplay :MASK:MDISplay? Function description When the pass / fail test is turned on, turn statistics on or off, or query the status of the statistics. Parameter Name Type Range Default Bool {{1|ON}|{0|OFF}} 0|OFF Description ▷Before executing this command, you need to send the: MASK:
ENABle command to enable the pass / fail test function. ▷When the statistical information is turned on, the test results shown in the figure below will be displayed in the upper right corner of the screen. ▷You can send: MASK: PASSed ?,: MASK: FAILed ?, and: MASK: TOTal? Commands to query the test results. Return format The query returns 1 or 0. Command format :MASK:SOOutput :MASK:SOOutput? Function description Turn output on or off, or query output stop status. Parameter Name Type Range Default