Chapter 1 Programming Overview Install IO software This oscilloscope can communicate with PC via USB, LAN, UART, WIFI instrument bus. The following will introduce how to use IO LibSuite software to remotely control the oscilloscope through USB interface. Operation steps: 1. Install Keysight IO LibSuite software. Log in to the keysight official website to download IO LibSuite software, and then follow the instructions to install. 2. Connect and configure the interface parameters of the instrument The DPO6000 / MPO6000 series can communicate with a PC via USB, LAN, UART, WIFI instrument bus. This manual uses USB as an example.
(1) Connect the device Connect the USB Device interface on the rear panel of the oscilloscope to the USB Host interface of the computer using a USB data cable. (2) Install the USB driver. The PC will automatically install the oscilloscope driver [At the same time, the USB Device icon will be displayed on the oscilloscope]. Open the device manager to view the device as follows: (3) Search for device resources Open IO, the software will automatically search for the instrument resources currently connected to the PC via the USB interface. You can also click “Rescan” to search. 9 / 136