Touch Screen Controls EN 6 Touch Screen Controls This series of oscilloscopes provides a 10.1 inch super capacitive touch screen, which supports multi-touch and gesture operation with high sensitivity. The functions supported by the touch screen include touch, drag, pinch, and rectangle drawing. Tip: The menus displayed on the oscilloscope screen and the enabled label buttons on the screen can both use the touch screen function. 1. Tap: Tap a menu or function on the screen with one finger, and the functions that can be achieved by touching include: ⚫ Touch the menu displayed on the screen to operate the menu. ⚫ Touch the pop-up numeric keyboard to set parameters.
⚫ Touch the virtual keyboard to set the tag name and file name. ⚫ Touch the close button in the upper right corner of the pop-up menu to close the pop-up box. ⚫ Touch other windows displayed on the screen to operate them. 2. Drag: After holding down the target, drag to the desired position. The functions that can be achieved by dragging include: ⚫ Drag the waveform to change its displacement or offset. ⚫ Drag the window to change its position. ⚫ Drag the cursor to change its position. 3. Pinch & Stretch: Bring two fingers together or apart. Pinching gestures can amplify or reduce the waveform.
Enlarge the waveform and slide the close fingers apart; Reduce the waveform and slide the separated fingers closer. As shown in the following figure. The DPO7000 Quick Guide Copyright © Qingdao Hantek Electronic Co., LTD 18