Aug.2001 DR-670 ERROR MESSAGE LIST fig.10-07 Incorrect operation or operation failure causes an error message to appear. MIDI Exclusive messages could not be received correctly. The following lists the possible error messages and actions to be taken. fig.10-01 Press [STOP/CONT] button and retry the operation. fig.10-07a The DR-670’s dry cells (batteries) are running low. Use the AC adapter, or replace the cells. The system failed to process data as it tried to concurrently process an abnormally large amount of data. Press [STOP/CLEAR] button to clear the message. Press [STOP/CONT] button.
If you continue to use the DR-670 at low voltage, sounds may be distorted or the unit may not operate correctly. Make sure that the unit is not being forced to handle an excessive amount of data (in patterns or MIDI message reception) at a time, and try to reduce the amount of data to be processed. fig.10-02 fig.10-07b The service life of DR-670’s memory backup battery has almost expired. (This message appears when the power is turned on.) Replace the battery as soon as possible. An unidentifiable error has occurred in the system. Consult the Roland Service Center for backup battery replacement. Caution:
Although you can clear the message by pressing [STOP/CONT] button and continue to operate the DR-670, recorded patterns and songs may be lost when you turn off the power. Shut down the DR-670 immediately. fig.10-03 Data stored in the DR-670 has been corrupted. You need to reset the data. (This message appears when the power is turned on.) Press [ ] button to restore the factory settings. fig.10-04 Memory is full. No more patterns or songs can be recorded. Press [STOP/CONT] button. To continue recording, first delete unnecessary patterns or songs. fig.10-04a The number of patterns recorded in the song exceeded 250. Press the [STOP/CONT] button.
You cannot record any further to the song currently being edited. To continue, create a new song, then use Song Chain. fig.10-05 When trying to copy or clear a pattern or song, no data to be copied or cleared has been recorded in the copy source and pattern and song. Check the pattern and song numbers of the copy source or data to be cleared. fig.10-05a A MIDI Active Sensing error has occurred. The devices or cables connected to the MIDI IN port have failed. Check the connected devices and cables. fig.10-06 The DR-670’s processing capacity was exhausted as it received too much MIDI data. Press [STOP/CONT] button.
Reduce the amount of MIDI data and send again from the MIDI device to the DR-670. fig.10-07c Reception of data during Bulk Load was cancelled before the operation was completed. Press the [STOP/CONT] button, then try carrying out Bulk Load again. 16