User Manual For example, you can take simple measurements by counting the major and minor graticule divisions involved and multiplying by the scale factor. If you counted 6 major vertical graticule divisions between the minimum and maximum values of a waveform and knew you had a scale factor of 50mV/division, you could easily calculate your peak-to-peak voltage as follows: 6 divisions x 50mV/division = 300mV. 2.10.2. Cursor measurement Cursor: This method allows you to take measurements by moving the cursors. Cursors always appear in pairs and the displayed readouts are just their measured values. There are two kinds of cursors: Amplitude Cursor and Time Cursor.
The amplitude cursor appears as a horizontal dotted line, measuring the vertical parameters. The time cursor appears as a vertical dotted line, measuring the horizontal parameters. The cursor measurement includes two modes: Manual mode and Tracking mode. 1. Manual mode: Horizontal cursors or vertical cursors appear in pair to measure time or voltage, and the distance between the cursors can be manually regulated. The signal source should be set as a waveform to be measured before the cursors are used. 2. Tracking mode: A horizontal cursor is intersected with a vertical cursor to form a cross cursor.
The cross cursor is automatically located on the waveform, and the horizontal position of the cross cursor on the waveform is regulated by selecting “Cur A” or “Cur B” and rotating the [UNIVERSAL] knob. The coordinates of the cursor point will be displayed on the screen of the oscilloscope. Push the CURSOR button to display the Cursor Menu. Mode Manual Select a measurement cursor and display it. CH1~CH2 Track Select a waveform to take the cursor measurement. Source MATH Use the readouts to show the measurement. AX(BX) Select Cursor AXBX A selected cursor is highlighted, which can be moved freely. Both cursors can be selected and moved at the same time.
The box behind the cursor AY(BY) displays the location of the cursor. AYBY Moving Cursors: Press the key near Select Cursor to select a cursor and turn Multifunctional Knob to move it. Cursors can be moved only when the Cursor Menu is displayed. 43 / 67 Options Settings Comments