User Manual Autoscale Autoscale setting. Source Select the source: only display the current source or all sources. Cancel Let the oscilloscope recall the previous setup. 2.15.2. Default Setup When you push the DEFAULT SETUP button, the oscilloscope will display the CH1 waveform and remove all the others. When you are at the default setup, press F5 to Undo Preset . Then the oscilloscope returns to the status before default setup. The table below gives the options, buttons and controls that change settings at default setup.
Acquire Mode Normal Operating status Run/Stop Run Cursor State Off Type Vectors Display Persist Off Display Mode YT Window Mode Single-window Trigger Knob Level Horizontal Position 0.00s SEC/DIV 200μs Math Status Off Measure Status Off Source CH1 Type Edge Trigger (Edge) Slope Rising Mode Auto Level 0.00v Bandwidth Limit Unlimited Vertical System, Probe Attenuation 1X VOLTS/DIV Coarse All Channels Invert Off Position 0.00div (0.00V) VOLTS/DIV 1V The following settings do not change when you push the [Default] button. Language Option Saved Settings Saved Reference waveform Display Contrast Calibration Data 2.15.3.
Dual-window Mode Press the Sec/DIV knob to enter the dual-window mode, and press the button again to exit the dual-window mode. 52 / 67 Menu or System Option, Button or Knob Default Setting